📞 Contact:+1 (626) 977 8228 ✉️ Email: [email protected]
Polypropylene Welding Machine

Polypropylene Welding Machine

What is Polypropylene Welding Machine?

When welding thermoplastics, one of the key parts is simply the material. So as to get a solid, predictable weld, it is important to ensure your substrate and your welding pole are indistinguishable; for example, polypropylene to polypropylene, polyurethane to polyurethane, or polyethylene to polyethylene

Hot Air Welding gun for Polypropylene Welding

 

Operation instruction of Polypropylene Welding Machine

  • ◎Fit proper nozzle as required.
  • ◎Connect apparatus to the power.
  • ◎Adjust air temperature.
  • ◎Switch on then use following 5 minutes.
  • ◎Do welding test as per national laws and controls or the material manufac
  • ◎turer's welding particulars.
  • ◎Check the result of welding test.
  • ◎Set welding temperature as need.
  • ◎Knob the temperature to zero point after use, cold airing a couple of minutes to chill off

ocompletely, at that point kill the power and keep them well.

 

Tips for Proper Welds of Polypropylene Welding Machine

Before welding thermoplastics with Polypropylene Welding Machine, there are a couple of straightforward advances that should be taken to guarantee an appropriate weld. Clean all surfaces, including the welding pole, with MEK or a comparable dissolvable. Furrow the substrate sufficiently huge to acknowledge the welding pole and afterward cut the finish of the welding pole to a 45° point. When the welder has acclimated to the best possible tem­perature, you have to prep the substrate and the welding pole. By utilizing an auto­matic speed tip a ton of the prep work is improved the situation you.

Holding the welder around an inch over the substrate, embed the welding bar in the tip and move it in a here and there movement three to multiple times. Doing this will warm the welding bar while warming the substrate. A sign the substrate is prepared to be welded is the point at which it begins getting a hazing impact — like blowing on a bit of glass.

Utilizing firm and reliable weight, push down on the boot of the tip. The boot will drive the welding pole into the substrate. On the off chance that you decide to, when the welding bar holds fast to the substrate, you can relinquish the bar and it will automati­cally pull itself through.

Most thermoplastics and Polypropylene Welding Machine are sandable and the quality of the weld won't be influenced when sanded. Utilizing 60-coarseness sandpaper, sand off the best piece of the welding dot, at that point stir your way up to 360-coarseness wet sandpaper to get a clean fin­ish. When working with polypropylene or polyethylene, it is conceivable to recapture their reflexive surface by delicately warming the surface with a yellow open fire propane burn. (Remember that nor­mal fire security methods ought to be fol­lowed.) Once these means are finished you ought to have a weld that looks simi­lar to the photograph at base left.

Leave a Reply

Close Menu